Accelerometer Spi

โดยสายสัญญาณ SDA และ SCL ต้อง By 3.bp.blogspot.com
Resolution: 292 x 186 · 14 kB · jpeg
Size: 292 x 186 · 14 kB · jpeg

The accelerometer has selectable full-scale range of ±2, ±4 or ±8 g and a 16-bit digital output, an integrated temperature sensor, industry-standard I2C and SPI interfaces, a wide analog supply-voltage range of 1.71V to 3.6V, and two programmable industry standard I2C and SPI interfaces, a wide analogue supply voltage range of 1.71 to 3.6V, and two programmable interrupt generators that help streamline system design. In addition, the accelerometer offers a typical Zero-g level change versus The accelerometer has selectable full-scale range of +/-2, +/-4 or +/-8 g and a 16-bit digital output, an integrated temperature sensor, industry-standard I2C and SPI interfaces, a wide analog supply-voltage range of 1.71V to 3.6V, and two programmable The accelerometer has selectable full-scale range of ±2, ±4 or ±8 g and a 16-bit digital output, an integrated temperature sensor, industry-standard I2C and SPI interfaces, a wide analog supply-voltage range of 1.71V to 3.6V, and two programmable The high performance 3-axis accelerometer in the LIS331EB iNEMO-A features a selectable as well as multiple timers and I/O ports (GPIOs/SPI/I2C/UART). The LIS331EB smart motion sensor will start sampling in Q2 2013. Unit pricing is US$2.4 for volumes This allows the system microcontroller unit (MCU) on the Arduino unit to access the shield’s FT121 USB device controller IC and the 3-axis linear accelerometer (STMicroelectronics’ LIS331DLH). Selectable SPI and I²C interfaces can be used to control .

ST's AIS328DQ senses acceleration along all three axes and converts the motion and tilt information into a high-resolution digital signal that it transmits to a microcontroller through a standard SPI or I2C interface. The accelerometer provides extremely The Arduino board’s microcontroller can access the shield’s FT121 USB device controller IC and the 3-axis linear accelerometer (STMicroelectronics’ LIS331DLH). Selectable SPI and I²C interfaces can be used to control the different axes of the Developers may also add hardware components and use standardized CMSIS drivers, for example to utilize communication interfaces such as I 2 C, SPI and USART on-board Ethernet and USB, an accelerometer and a magnetometer, and large on-chip RAM and When microelectromechanical systems (MEMS) accelerometers were initially introduced about C and the ADIS16365 is from −40°C to +85°C. The Epson S4E5A0A0 6DoF sensor has an SPI and a UART interface. Another 6DoF sensor that addresses industrial .

Another Picture of accelerometer spi:

ANT+ / BT Schematics



TITLE_IMG3



TITLE_IMG4



TITLE_IMG5



TITLE_IMG6